There are four functions to choose from:
1. Sound mode: beeps to remind pets, recommended,
2. Vibration mode: the receiver vibrates to remind pets, the vibration size can be adjusted, it is recommended to use,
3. Electric shock mode: Use static electricity to shock pets to give a serious warning function, will not harm pets, pain is inevitable, use it as a last resort! (Long-haired dogs need to trim off their neck hair, so cut a small amount to prevent the two conductive posts from touching the skin)
4. Lighting mode: It is more convenient and safer to walk the dog at night.
product description:
1. The remote control is made of ABS plastic, rechargeable with lithium battery, luminous blue screen, 1-99 gears to adjust vibration and electric shock
2. The receiver is made of ABS plastic, rechargeable with lithium battery, IP7 degree waterproof, and can be worn for swimming
3. Suitable for all kinds of dogs of different sizes (it is recommended that dogs should be more than 2 kilograms, and the neck circumference should be within the range of 20-70cm)
Product signal pairing:
1. First press the "CH" key on the remote control panel, adjust to CH1, there will be a font display on the left side of the screen, then press the "vibration" key, the corresponding vibration symbol will be displayed on the right side of the screen, and then press Change the number with the "+" or "-" sign, it’s not 00, then press the receiver’s on-off key to turn on the receiver, you will hear a beep when turning on (if the two beeps are turning off), press and hold the on-off key when it is turned on The indicator light will flash in about two seconds, immediately press the "vibrate" button on the remote control, then the receiver will vibrate accordingly, and the signal pairing is successful. (If the receiver does not respond, see which link is wrong, please re-operate the signal distribution)
2. If it is one for two or one for three, after configuring a receiver, adjust the "CH" key to CH2 or CH3, and use the same operation as before to configure another receiver. After the signal is configured, you can press " CH" key to switch multiple receivers to control the corresponding dogs.
3. The remote control has no switch key, it will automatically enter the standby state when not in use, just press any key to start it